Emergency update 1.2.26Issuing time:2018-01-12 15:45 The firmware version, 1.2.25, has only been downloaded for 20 hours. We have already deleted it. If you have updated this version, please renew it to 1.2.26. 1.2.26 for MT1.5 300 400X400X500is <300degree, print size for 400x400x400,400x400x500 1.2.26 for MT1.5 400 400X400X500is <400degree, print size for 400x400x400,400x400x500 ..... when you uploaded,do this Main menu -> Control -> Initialize EEPROM -> Initialize EEPROM If you want source, please email us. tech@multoo.com Add new item in menu, Main menu -> Multoo -> enable PIRP, is for 'auto resume print', we call it 'Power interruption resume print', short to call 'PIRP'. If there is an unexpected power off, then when the power is restored, you can continue to print. This function is used for some customers. These customers have this power break module. Then you can use it. If you don't have this module, the function is invalid. If you can use this function, then set it to Main menu -> Multoo -> enable PIRP on, If you don't have a power off check module, then set it to Main menu -> Multoo -> enable PIRP off. Main menu -> Multoo -> Filament Warning Main menu -> Multoo -> Filament Warning -> enable FW1, Main menu -> Multoo -> Filament Warning -> enable FW2, Old users, such as MT1.5, are wire alarm modules. If you want to use these two modules, you can set these two options. For new users, because of the old user feedback, the use of this function is not much, so there is no increase in this module. Of course, if new users want to use this function, please contact us. We will give you these two modules.
Article classification:
Updates
|