Firmware 1.3.2.17Issuing time:2019-11-18 19:22 Thisversion is mainly designed for whether or not to add G29 to theslicing software. Pleaseupgrade the MT2X user. If you are used to the previous printingmethod, you can not upgrade. ---------- Inother words, if you don't want to add G29 to the slicing software,then you can. Beforeupdating, please record the following parameters. Mainmenu → Multoo → probe offset, Mainmenu → Multoo → E2 offset to E1 → X offset Mainmenu → Multoo → E2 offset to E1 → Y offset Mainmenu → Multoo → E2 offset to E1 → Z offset ------------ Thenyou can update the firmware. Afterthe update, set the above four parameters back. Mainmenu → Multoo → probe offset, set back Mainmenu → Multoo → E2 offset to E1 → X offset, set back Mainmenu → Multoo → E2 offset to E1 → Y offset, set back Mainmenu → Multoo → E2 offset to E1 → Z offset, set back Mainmenu → Multoo → comfirm settings ------------ Then,execute Main menu → Prepare → Bed leveling Thenyou can no longer add G29 in the slicing software. PrevFirmware 1.3.3
NextFirmware 1.3.2.8
Article classification:
Updates
|